Exterior Assembly
Lever Assembly
Assembly/Verification
Interior Mechanism Housing
make sure
There is a spring button on the tube
of the assembly. It should point
away from the door edge toward
the hinge side of the door. For
keyed entry levers, the release
button should point towards the
door’s edge. Insert the square
spindle of the exterior assembly
through the cam of the lower latch
and insert the connecting screws
loosely. Tighten these two screws.
Line up the hole in the neck of the
lever with the release button, then
slide the lever until the button
aligns with the hole. Using a key,
nail, or other pointed tool, depress
the button and push the lever onto
the tube until the button snaps into
the hole in the neck of the lever.
Using a key from the exterior,
operate the deadbolt latch to insure
correct alignment. Operate the
exterior lever insuring smooth
operation. If the deadbolt or the
exterior lever does not operate
smoothly, adjust the installation
plate up and down or side to side to
find the correct position then
tighten all four connecting screws.
Reinstall the interior mechanism
housing on the installation plate
with the two self-thread screws
saved before. Once this operation
is done,
the square
spindle for the interior mechanism
housing is inside the hub of the
lower latch and operates the latch.
Note that the thumbturn must be in
the vertical position, then slide the
lever over the bottom tube and
proceed same as with the exterior
assembly.
2
An ASSA ABLOY Group brand
P/N 80-9510-0056-010 Rev B
DEADBOLT LATCH
INSTALLATION
Insert latch through the hole in the
door edge and screw in place using
two 3/4" Phillips head screws. There
is a rectangular slide cam on the
back side part of the latch This is the
top of the latch. It should be up.
DO
NOT INSTALL WITH THIS
POINTING DOWN.
Latchbolt Fig. 2
Plastic Sleeve
BACKSET ADJUSTMENT
Firmly push and hold tab. Pull
deadbolt apart for 2-3/4"
backset and push together for
2-3/8" backset.
Make sure tab
is held in through motion.
Tab
LATCH INSTALLATION
Insert latch with plastic sleeve
through the hole in door edge and
screw in place using two 3/4" Phillips
head screws. Curved edge of latch
bolt should face in direction that door
closes.
Deadbolt Fig. 1
EXTERIOR LEVER
INSTALLATION
