1
2
1030482G - 2/6
Using a screwdriver, tighten
by turning the screw in each
of the Strap Caps clockwise
until the Cap is just secure.
Firmly push a Strap Cap
onto the end of each
Crossbar.
END CAP
REMOVE THE END CAPS
FROM YOUR CROSSBARS.
PUSH THE CENTER ANCHOR ONTO
THE MIDDLE OF THE CROSSBAR.
(You will readjust it when your board
is up there).
Push the bolt through and loosely
attach the Turn Key.
ATTACHING THE CENTER ANCHOR
• Pull cord back firmly into slots, and
push down securely into cinchers.
• Repeat with other cord.
THREADING THE RUBBER CORD
SLIDE THE OPEN RUBBER LOOP OVER THE STRAP CAP.
CENTER ANCHOR
TURN KEY
BOLT
CROSSBAR
INSTALLING THE STRAP CAPS
FAILURE TO PULL CORD BACK FIRMLY INTO SLOTS, AND PUSH
DOWN SECURELY INTO CINCHERS COULD CAUSE LOSS OF
BOARD(S), PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
HOLE
RUBBER LOOP
STRAP CAP
RUBBER
CORD
• Insert one rubber
cord into hole as
shown.
SLOT
