1033066A-3/12
CENTER THE BAR.
INSTALL THE CROSSBAR (purchased separately).
Tighten the
clamps until the
bar cannot
rotate.
ATTACH END
CAPS.
PERFORM A FINAL TIGHTENING.
TIGHTEN THE
BAR CLAMPS.
TIGHTEN THE ANCHOR
BOLTS SECURELY.
Use the wrench
to loosen the
clamps if needed.
CHECK THE INSTALLATION: Lift and pull.
Lift the bar upward.
Pull the strut from
front to back.
Tighten again if anything is loose!
If the bar appears to be at an awkward
angle to the rack, loosen the anchor
bolt slightly to permit loading.
INSTALL SECOND BRACKET.
Match the position of the first bracket.
Measure from edge of bed to the bracket for best results.
Do not tighten second bracket until crossbar is installed.