2
1
Center craft
on saddles
1
Insert plain strap into notch
at top of
OUTBOARD
saddle.
2
Insert
BUCKLE
strap into
notch at top of
INBOARD
saddle.
2
Insert end of plain strap
into buckle as shown.
3
Loop straps through
saddle, placing straps in
groove on underside of
each pad.
4
Insert shark chucks securely
into slot in nose of each saddle.
3
Tighten straps.
Place
SnapArounds on
FRONT crossbar.
Push SnapArounds onto
crossbar facing in opposite
directions as shown.
If you are using MightyMounts,
follow the MightyMount
instructions.
Install a
second pair
of Saddles or a
pair of Hully
Rollers on REAR
crossbar. Repeat
steps 1-5 for
other Saddle or
follow installation
instructions for
Hully Rollers.
Place craft in Saddles. Adjust position of
Saddles as needed. Loosen SnapArounds
thoroughly before sliding Saddles along
crossbars.
When Saddles
are positioned
as desired,
tighten
SnapArounds
completely.
Tighten Straps
Install Saddles
Load Craft
Test movement by
rocking boat.
Tighten again if loose.
Install Straps
OUTBOARD
INBOARD
1
Slide rubber-buckle
protector up the strap.
Install Saddle using two
SnapArounds. Push bolts through
SnapArounds, then into Saddle.
Attach hex keys and tighten.
Repeat for other saddle.
Install SnapAround
