3
2
Limited Warranty
: Yakima Products (“Yakima”) will repair or replace merchandise which proves defective in materials and/or workmanship. The limited warranty is effective for one year from the date of purchase. The limited warranty is applicable only if the Fit List and
instructions are followed and the products are used properly. If a customer believes that a Yakima product is defective, the customer must return it to an authorized Yakima dealer with proof of purchase. Yakima will then issue authorization to the dealer for the return of these
products. If an article is found to be defective upon inspection by Yakima, Yakima will repair or replace the defective article at its discretion without charge. The customer will pay freight to Yakima, and Yakima will pay any applicable return freight. Unauthorized returns will not
be accepted. Normal wear and tear of Yakima products or damage resulting from misuse, accidents, or alterations are not covered by this Limited Warranty.The purchaser acknowledges that Yakima has no control over the attachment of its products to vehicles or the attachment of
items to the Yakima products. Accordingly, Yakima cannot assume responsibility for any damage to any property arising out of the improper attachment or use of its products. In addition, this Limited Warranty applies only to Yakima products and not to other products used in
conjunction with Yakima products. This Limited Warranty is in lieu of all other warranties, expressed or implied, and does not cover consequential damages of any kind that may arise from the use or misuse of any Yakima product.
1
Place SnapArounds on FRONT
crossbar. Push SnapArounds
onto crossbar facing in opposite
directions as shown.
If you have square bars, see
front page for SnapAround
instructions.
Place craft
in Saddles.
Loosen hex keys
enough to adjust
position of Saddles. Saddles can be slid along crossbars
and rotated on SnapArounds.
Install Saddles
Load Craft and Adjust Position
Test movement by rocking boat.
Tighten again if loose.
Install Saddle using two SnapArounds.
Push bolts through SnapArounds, then into
diagonally opposite holes in the Saddle.
Attach hex keys and tighten. Repeat for
other Saddle. Repeat for Saddles on REAR
crossbar.
Install SnapArounds
Fit Boat to Saddles
Tie Down
Center craft
on saddles
Top-view
Do not loop straps through saddles!
Attach to crossbars only.
Use straps to secure craft. Loop strap
around front crossbar as shown. Be
sure that strap is INBOARD of tower.
Repeat for rear crossbar. (Buckle
strap shown is sold separatley).
TIGHTEN
BEFORE DRIVING AWAY!
Tie down front AND rear of
craft to vehicle.
Be sure all hardware is secured
according to instructions.
Position your
boat to allow
maximum contact
with Saddle
surfaces. Saddles
will deform for a
close fit with hull
after straps are
tightened. When
saddles are
positioned as
desired,
TIGHTEN
HEX KEYS COM-
PLETELY.
