90°
1033615B-2/24
Open jaws.
Attach ForkLift jaws to front crossbar.
Close jaws around crossbar.
Pass the t-bolt through the opening in lower
jaw. Rotate t-bolt to rest in slot.
Tighten the knob, but don’t tighten all the
way. Final tightening will occur after rear
clamp has been installed.
Open slider.
Use caution to avoid hardware damaging
roof’s finish. A towel placed on the roof prior
to installation can help avoid scratches.
Loosen knob.
Open locking slider, loosen knob, open jaw.
For low clearance crossbars:
Hold ForkLift at an angle
while positioning jaw around
crossbar to avoid any contact
with your vehicle’s roof.
For factory bars choose the best
position for most secure grip.
Adjust jaw if necessary.
(Upper notch for round
and square bars.)
If you don’t get a secure grip with
your factory bars adjust jaw.
A
B
C
