Instruction #1036093B-1/9
Tools Required
• Outils Nécessaires • Herramientas Necesarias
Diamondback Base Track
• power drill
• 1⁄8” drill bit
• 1⁄4” drill bit
• marking pen
• tape measure
• 1⁄8” Allen wrench
• perceuse électrique
• mèche de 3 mm (
1⁄8
po)
• mèche de 6 mm (
1⁄4
po)
• marqueur
• ruban à mesurer
• clé Allen de 3 mm (
1⁄8
po)
• taladro eléctrico
• mecha de 1⁄8 pulg.
• mecha de ¼ pulg.
• marcador
• cinta métrica
• llave Allen de 1⁄8 pulg.
CONTENTS
• CONTENU • CONTENIDO
Para español ir a la página 6.
Pour le français, aller à la page 6.
1
DETERMINE WHERE THE CROSSMEMBERS, HANDLES,
OR OTHER OBSTRUCTIONS ARE LOCATED.
crossmember
traverse
travesaño
crossmember
handle
manija
poignée
• Open the panels of your cover and locate the crossmembers on
each panel. When you mark and drill the holes to mount your tracks
in a subsequent step you must avoid these crossmembers. Look for
any other potential obstruction and make note of their locations.
NOTE:
The SE cover
has 1 crossmember
per lifting panel and
the HD cover has 2
or 3 crossmembers
per lifting panel.
• You must also avoid installing the
tracks above the handles to avoid
interference.
• You will need to secure the ends of
each track so it’s important that you
make sure there is no obstruction
where the ends of track will be placed.
To allow clearance for cap nuts, the
holes must be a minimum of 3⁄4” from
cross members or other obstructions.
track end caps (8X)
obturateur de glissière (x 8)
protector terminal de riel (8X)
HD tracks (4X)
glissière HD (x 4)
riel HD (4X)
cap nuts (16X)
écrou borgne (x 16)
tuerca capuchón (16X)
button head screw (16X)
vis à tête ronde (x 16)
tornillo de cabeza redonda (16X)
washers (16X)
rondelle (x 16)
arandela (16X)
