![background image](http://html.mh-extra.com/html/yakima/copperhead/copperhead_manual_893671005.webp)
R8A9N1D
ºC
ºF
If forks move out of the skewer —
Open lever and tighten the brass
wheel slightly. You may need to
loosen or tighten the brass wheel
so that lever closes firmly with
resistance.
If the wheel is loose in the tray —
Pull down on the strap end. Some bike
wheels may be too narrow to allow
a tight fit. Slide
the strap in the
tray until it rests
against the rim.
If pod can slide —
Remove the skewer and pod cover,
and tighten the screws. Always
replace the pod cover.
•
This bike carrier is designed for bikes that use standard 100mm x 9mm quick release front hubs. Do
not carry bikes with other hub standards (qr15, all thru-axles, maverick, lefty, etc.) Without approved
adapters.
•
Bicycle fork must be equipped with safety tabs. Removal or alteration of safety tabs will void warranty
when used with this carrier.
•
Failure to properly install, adjust, use, and maintain the quick release mechanism on this carrier may
result in damage to the vehicle and bike as well as serious personal injury.
•
Any modification to bike dropouts can cause insufficient fork mount clamping pressure and may result
in damage or loss of bike.
•
Do not carry bikes with disk wheels, wheels covers, baby seats, panniers, bike covers or motors.
•
Do not carry tandem or recumbent bicycles.
•
Off-road driving is not recommended.
•
Not all forks are compatible with Yakima mounts. If your fork has a unique feature or design that
prevents the mount from being used in accordance with these instructions, do not use it.
READ THESE WARNINGS:
TEST THE STAbIlITy OF THE INSTAllATION by TuGGING ON FORk lEG.
1033568C - 5/18