Sheet 1 0f 3
Part #1031695 RevA
Open red lever.
Remove red
lever
assembly.
Flip lever assembly and reattach.
Separate plates
and lift arm out.
You must change the position of the ”dog“—
• FOR LOADING as shown
above, begin instructions on
reverse side of this sheet.
• TO CHANGE the loading
side, start here.
ON WHICH SIDE
of
the vehicle do you want
to carry your bicycle?
Align bump to
hole in arm.
Replace arm into plate assembly.
Dog should be looking away from
plate opening.
Use the SHORTEST bolt to attach wheel tray to arm assembly.
Tighten.
Insert tray
lock at
back of
wheel tray.
Insert the shorter
bolt into the rear
end of the wheel
tray.
Install
snaparounds.
Attach rear hex
key and tighten.
FOR LONG CROSSBAR SPREAD, attach rear
wheel strap before the short bolt.
To attach front hex keys, first raise
arm into a vertical position.
Insert bolts,
and attach hex keys.
Tighten keys so that
they align with
wheeltray.
For short crossbar spreads, attach front
and rear wheel straps.
Now you are ready to load your bike.
SEE OTHER SIDE for loading your bike,
and for locking the AnkleBiter to your rack.
Slide the dog up to
Rotate the dog 180
°
.
Slide the dog back
sleeve on arm.
onto rivets.
Set tray assembly on bars with short bolt
inserted into snaparound.
Approximately* 12" / 30cm
*
This distance will
require
adjustment for
varying bike
styles.
