1033593A-1/6
Locking BedHead
Hold the adjustment knob. Turn
handle clockwise to remove the shaft.
Remove shaft from handle.
Open handle.
NOTE: Shaft will turn with adjustment knob.
Insert skewer.
Insert the shaft into your fork
block by twisting while pushing.
Install Locking Skewer.
Hold the shaft at the far end. Join the handle with
the shaft, turn the shaft counter-clockwise.
Attach shaft.
NOTE: Adjustment knob will turn with shaft.
Load Bike.
Position Rail Clip.
Loosen Bolt.
Hook rail clip under bed rail.
Position rail clip only where
underside of rail is flat.
Loosen
bolt more if necessary, and
rotate into upright position.
Position Fork Block.
Slide fork block into position
with rail clip as shown.
Set the bicycle forks onto the skewer.
The Bedhead is designed to attach
to standard pickup bed rails. Bed
liners may need alteration.
Use enclosed wrench and loosen
enough to separate pieces.
Check that rail clip is
positioned where the
underside of rail is flat
or
remove rail clip and rotate
the black, rectangular pad.
Reassemble and TIgHTEN.
If BedHead is not flat
on rail or will not fit:
Be sure that bolt aligns with
indentation in the fork block.
Do not overtighten. TEST
by grabbing and shaking.
If BedHead slips or loses
contact with rail, tighten more.
Tighten.
1033593 Rev.A
