Yaesu ZCUT-9, Instruction Manual, Page: 30 / 48

30
IF THE MACHINE STILL CAN NOT OPERATE PROPERLY, STOP USING THE MACHINE C )
IMMEDIATELY AND CONTACT VENDOR FOR REPAIR AUTHORIZATION.
!
TROUBLE SHOOTING
SPECIFICATIONS
PROBLEM POSSIBLE REASON SOLUTION
Before returning the machine for repairing, please check the followings.
Power Requirement 100-240VAC 50/60Hz
Input Voltage Range ±5%
Wattage 25W
Dimensions 116 mm(S) x 140 mm(W) x 213 mm(G)
Weight 1.6 kg.
Body Material ABS
Tape Length 5 mm ~ 999 mm
Tape Width 6 mm~60 mm
Feeding Speed 200 mm/s. (using Craft Tape)
Max. Outside Dia. of Roll 300 mm
Accessories 24 Fuse (built-in inlet)
Separator / Guide Plate / Blade Oil
Remarks
• The specifications are subject to change without prior notice.
• The length of the tape may differ from the set length depending upon the type of the tape or its condition.
• Some types of tape available with the machine may not be cut depending upon conditions.
The POWER SWITCH is on but
the machine can not run. The AC CORD is loosen.
The FUSE has been blown. Check the AC CORD then plug in the outlet
firmly. Replace the FUSE.
Stop using the machine immediately even
though the FUSE is blown again after replace
After removing piece of tape, the next piece
does not feed under AUTO mode. The mode is set MANUAL.
Some debris are covering on the SENSORS.
The tape can not goes through the SENSORS.
The tape has extremely low reflectance. Set the mode to AUTO.
Remove the debris.
Use SEPARATOR to narrow the tape lesser
than 25mm,
Do not bring strong illuminant close around
the SENSORS.
Some types of tape may not be used under
AUTO mode.
The BLADE can not move smoothly. The BLADE UNIT is not in a proper position. Check the BLADE UNIT and push down on
the housing firmly.
The length of the tape is different from the
set length. The adhesive of tape is too strong.
The elasticity of tape is too strong. Correct the setting after cutting several
test pieces.
Tape curls excessively. The machine is not grounded.
The ROLLER LOCK is disengaged. Check ground on cord.
Engage the ROLLER LOCK to apply tension.
ENGLISCH
INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10