Yaesu ZCUT-9, Instruction Manual, Page: 23 / 48

23
SET THE TAPE LENGTH
MODE SETTINGS
Make sure that DISPLAY indicating <cutting length>.
The cutting length is always indicates in some alphabets like A,b,C,d,E,F.
Set the cutting length.
Set your needed length by using +/- BUTTON.
The cutting length is adjustable in between 5 mm to 999 mm.
Can set six different length by using SELECT BUTTON.
If you press +/- BUTTON in a short while, the length in changed to 1 mm.
And if you press +1- BUTTON longer, if shows fast forward.
MANUAL MODE
Make sure that blue LED LAMP is off.
When the LED LAMP is flashing or turned on, press AUTO/MANUAL MODE and turn off the LED
LAMP.
Press the START BUTTON once, the machine will feed-in a piece of tape then cut it out based on
your set length.
To cut another piece, press START BUTTON again.
AUTO MODE
Make sure that the LED LAMP is flashing.
When the LED LAMP’s lights are off, press AUTO/MANUAL BUTTON and let the LED LAMP to
flash.
Press the START BUTTON once, the machine will feed-in a piece of tape then cut it out based on
your set length.
When that piece of tape is removed, the machine will feed-in another piece then cut it out.
The machine will feed-in and cut a new piece of tape once the piece of tape is removed.
Caution
The actual length is differ from the displayed length depends on the type of the tape and its
condition.
When cutting short length of tape, the length may not cut consistently or tape is jammed.
Try several test cuts to insure proper operation.
If pressing —BUTTON for setting from b to F, you will be able to set ZERO.
However, machine will not start while alarming even though pressing START BUTTON.
ENGLISCH
INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10