FCC ID: K66VX-2500V
Alignment
Vertex Standard Co., Ltd.
4/6
directly as you think fit, and copy this file. That is all of the installation process.
Boot the tool
Change directly and input in command line, " svc47 [enter] ", and boot the alignment tool.
Preparation
Setup the test equipment as "Alignment Preparation & Precautions".
Set the RF Ch. List to Table1 on the CE47 Clone editor software.
Enter to the alignment mode
To enter the alignment mode, and press "[0] Alignment Mode" on the personal computer Key
board. You turn off the power of the transceiver, and turn on the transceiver. If entry
succeed,the alignment tool display as follows.
[0]Common TX
[1]Common RX
Action of the switches
When the transceiver is in alignment mode, the action of [PTT], [MON],[UP],[DOWN] is
ignored. All of the action is remote controlled by PC.
Menu of the tool
[0]Common TX
- [0] Tx Power High
This parameter is used to align TX High power (25W).
Press [Enter] on "[0] Tx Power High" to align TX High power.
Select the Channel 1 in alignment range.
Press the [Space] key on the keyboard to activate the transmitter.
Press the [UP]/[DWN] key, as need, to set the power output to the following
specification, as indicated on the external wattmeter.
Tx Power High:25[W](
±
0.5W)
When the 25Watt level is attained, press [Enter] to lock in the new data.
- [1] Tx Power Low
This parameter is used to align TX Low power (5W).
Press [Enter] on "[1] Tx Power Low" to align TX Low power.
Select the Channel 1 in alignment range.
Press the [Space] key on the keyboard to activate the transmitter.
Press the [UP]/[DWN] key, as need, to set the power output to the following
specification, as indicated on the external wattmeter.
Tx Power Low:5[W](
±
0.1[W])
When the 5Watt level is attained, press [Enter] to lock in the new data.
- [2] VCO Deviation
This parameter is used to align the VCO Deviation.
Press [Enter] on "[2] VCO Deviation" to align VCO Deviation.
Select the Channel 1 in alignment range.
Adjust the AF generator output level to 388mVrms(-6dBm) at 1 kHz to the pin3 of the
J1502 (-sub 9pin ).
Press the [Space] key on the keyboard to activate the transmitter.
Press the [UP]/[DWN] key, as need, to set the VCO Deviation (Wide) to the following
