14
VL-2000 Operating Manual
Installation & Interconnections
G
enerAl
T
rAnSceiver
Be sure both transceiver and
VL-2000
are turned off, then follow the installation recommendation contained in the illus-
tration.
i
mporTAnT
n
oTe
!
r
The general transceiver enables to connect only to the
INPUT 2
connector. Set the
INPUT
switch to the “
INPUT 2
”
side after assemble the equipment.
r
The ALC cable must be connected between the transceiver and
VL-2000
to prevent overdrive of the amplifier, and
especially to facilitate the proper operation of the protection circuitry if sudden antenna system problems should cause
the SWR to rise to dangerous levels.
r
Do not attempt to connect or disconnect coaxial antenna cables when your hands are wet.
n
oTe
r
When the
VL-2000
POWER
switch is turned “off”, the exciter output is delivered as follows:
¦
INPUT 1
exciter: delivers to the
ANT 1
connector directly.
¦
INPUT 2
exciter: delivers to the
ANT DIRECT
connector directly.
VL-2000
FCC ID: K6620321X70
Vertex Standard Co., Ltd.
