![background image](http://html2.mh-extra.com/html/yaesu/m-1/m-1_operating-manual_3095352007.webp)
5
Controls & Connections
M-1 Operating Manual
MIC
The unit includes a built-in dynamic microphone and a condenser micro-
phone that are developed for communications equipment. The condenser
microphone provides crisp sound with transparent frequency characteristics
up to high frequencies. The dynamic microphone produces a thick, deep,
warm sound quality that is suited for informal chatting. These two types
of microphones are each equipped with an independent 9-band graphic
equalizers, allowing the output frequency characteristics of the separate
elements to be precisely controlled. It is also possible to combine the audio
output signals from the two microphone ele-
ments.
r
The included treble boost cowling may be
installed to block sounds from the sides of
the microphone, resulting in unique frequen-
cy characteristics as if the sound were con-
densed with a peak response in the vicinity
of 1 to 1.5 kHz. To install the cowling, press it
straight on from the front to cover the micro-
phone. To remove, slide it straight off.
Angle adjustment knobs
The angle of the microphone may be adjust-
ed by loosening (turn counterclockwise) the
knobs on the left and right side of the pivot
top. Place the microphone in the desired po-
sition and then tighten the knobs (turn them
clockwise) to secure the microphone.
Height adjustment ring
The height of the microphone can be pre-
cisely adjusted. Turn the compression ring
counterclockwise to loosen the top tube,
and then raise or lower the top section to
the desired position. Turn the compression
ring clockwise to tighten it and hold the mi-
crophone in place.
r
The stand can be extended a maximum of 6
cm.
Treble boost
cowling
Summary of Contents for M-1
Page 1: ......