Yaesu FTM-6000R, Operating Manual

Page: 29 / 48

27
Setting the Receive Operation When Scanning Stops
1. Press and hold the [ F menu ] key.
2. Rotate the DIAL knob to select [ 23 SCN.TYP ], then
press the DIAL knob.
“ SCN.RSM ” is displayed.
3. Press the DIAL knob again.
4. Rotate the DIAL knob to select the hold time after the
scan is paused:
• BUSY
The signal is received until the signal fades out.
Two seconds after the signal fades out, scanning re-
sumes.
• HOLD
Scanning stops and tuning remains on the current
receive frequency (Scanning does not resume).
• 1 sec / 3 sec / 5 sec
The signal is received for a specified period of time, and then scanning resumes.
5. Press the DIAL knob to complete the setting.
The above settings are common for all scanning operations.
Skip Memory Channels
Each memory channel can be set to be skipped during memory scan.
1. Select the memory channel number not to be
scanned.
2. Press and hold the [ V/M mw ] key.
3. Rotate the DIAL knob to the right to select [ SCAN ],
then press the DIAL knob.
4. Rotate the DIAL knob to select [ SCAN N ].
5. Press and hold the [ V/M mw ] key to complete the set-
ting.
To re-institute a channel into the scanning loop, select “SCAN” in step 4 above (the “Skipped”
channel will still be accessible via manual channel selection methods using the DIAL knob in
the memory mode, whether or not it is locked out of the scanning loop).