Yaesu FTM-200DR, Operating Manual

Page: 35 / 82

33
Using the convenient Digital C4FM features
About the Digital Group ID (DG-ID) feature
Digital Group ID (DG-ID) function permits using the two-digit ID numbers to communicate
only with specific group members. The desired DG-ID number from 00 to 99 is set in
advance by all the group members. This ID number may be set separately for transmit
and receive, when the same ID number is set for both transmit and receive, only group
members with the same ID number will be heard. This feature may be used to limit
communication only to group members that have the same DG-ID number. The GM
function may also be utilized to automatically monitor whether or not group member
stations with the same DG-ID number are operating within communication range.
The DG-ID number 00 detects signals with all ID numbers. Normally setting the ID
number to “00” for both transmit and receive will permit reception of the signals from all
other stations using the digital C4FM mode, regardless of the transmit DG-ID number
settings of the other stations.
Also note that when the receive DG-ID number of the transceiver is set to a DG-ID
number other than “00”, received signals that do not have the same DG-ID number may
not be heard.
When accessing a C4FM digital repeater controlled by a DG-ID number, set the transmit
DG-ID number of the FTM-200DR/DE to that of the repeater input. Even in that case, if
the receive DG-ID number of the FTM-200DR/DE is set to “00”, all the downlink signals
from the repeater may be received.
Communicating with the DG-ID feature
• Digital C4FM mode transceivers compatible with the DG-ID function are required in order to
utilize this function.
• If the firmware is not compatible with the DG-ID function, update to the latest firmware to use the
DG-ID function. The latest firmware is available on the YAESU website.
Setting the transmit and receive DG-ID number to “00” to communicate
with all other stations using C4FM digital mode
1. Press and hold the [ GM ] key.
The DG-ID number setting screen will be displayed.
While setting the DG-ID number, pressing and holding the DIAL
knob will set the transmit and the receive DG-ID numbers to
“00”.
2. If the transmit DG-ID (DG-ID TX) number is not set to
“ 00 ”, press the DIAL knob, and then rotate the DIAL knob
to set “
00
”.
3. Press the DIAL knob again, and rotate the DIAL knob to
select the receive DG-ID (DG-ID RX).
4. If the receive DG-ID number is not set “
00
”, press the
DIAL knob, then rotate the DIAL knob to set “ 00 ”.
DG-ID SETUP
DG-ID TX
DG-ID RX