44
y
78 APRS TX DELAY
Set the data sending delay time.
Setting item:
100 ms / 150 ms / 200 ms / 250 ms / 300 ms / 400 ms / 500 ms / 750 ms
/ 1000ms
Default:
250 ms
Explanation:
The preamble (data transmission delay time),
shown right, for when transmitting APRS data
can be set.
y
79 APRS UNITS
Unit setting for APRS display.
Setting item:
POSITION: dd°MM.MM' / dd°MM'SS"
DISTANCE: km / mile
SPEED: km/h / mph / knot
ALTITUDE: m / ft
BARO: hPa / mb / mmHg / inHg
TEMP: °C / °F
RAIN:
mm / inch
WIND: m/s / mph / knot
Default:
Depends on the transceiver version.
Explanation:
Set the measurement unit for Latitude/Longitude (POSITION), DISTANCE, SPEED,
ALTITUDE, Barometric pressure (BARO), Temperature (TEMP), Precipitation (RAIN),
and Wind Speed (WIND).
POSITION: Unit display of minute of Longitude/Latitude (dd°mm'ss" can be changed.
mm’ is displayed in 1/100 minute and ss” in seconds.
DISTANCE: Unit can be set to [km] or [mile].
SPEED:
Unit can be set to [km/h], [mile/h] or [knot].
ALTITUDE: Unit can be set to [m] or [feet].
BARO:
Unit can be set to [hPa], [mb], [mmHg], [hPa] or [inHg].
TEMP:
Unit can be set to [°C] or [°F].
RAIN:
Unit can be set to [mm] or [inch].
WIND:
Unit can be set to [m/s], [mile/h] or [knot].
Start Transmission
APRS beacon transmission content
APRS Data
Preamble
(data transmission delay time)
(Default: 250ms)
End Transmission
Hours
