Yaesu FTM-10, Operating Manual

Page: 86 / 112

84 FTM-10SR O
PERATING
M
ANUAL
T
IME
S
YSTEM
You may select the Time System between “12H” and “24H” via the Menu mode.
1. Press the [
VOL/SEL
] key repeatedly to display the Clock, Stop Watch Timer, or Ther-
mometer.
The display returns to the frequency display automatically if you leave an interval of
approximately three seconds before the next operation. Please operate the next step
within the 3 second interval.
2. Press and hold the [ VOL/SEL
] key for one second.
3. Rotate the
DIAL
knob to select the Menu Item “
T4 12H
/
24H
”.
4. Press the key momentarily. Then rotate the DIAL knob to select the desired Time
System.
5. Press the [ VOL/SEL
] key to save the new setting and exit to normal operation.
A
LARM
S
ET
You may set an alarm beep which will sound every “00” minutes via the Menu mode.
1. Press the [ VOL/SEL
] key repeatedly to display the Clock, Stop Watch Timer, or Ther-
mometer.
2. Press and hold the [ VOL/SEL
] key for one second.
3. Rotate the DIAL knob to select the Menu Item “
T2 CLOCK BP
”.
4. Press the key momentarily. Then rotate the DIAL knob to change the setting to
“
ON
”.
5. Press the [ VOL/SEL
] key to save the new setting and exit to normal operation.
To turn the alarm off again, select “
OFF
” in step 4 above.
I
NTERVAL
B
EEP
The FTM-10SR ’s Stop Watch Timer allows programming a timed interval when a beep
will sound and the white LED will flash.
1. Press the [ VOL/SEL
] key repeatedly to recall the Clock/Timer mode.
2. Press and hold the [ VOL/SEL
] key for one second to activate the Clock/Timer
Customization mode.
3. Rotate the DIAL knob to select Menu Item “T5 TMR BEEP”.
4. Press the key momentarily to enable selection of this Menu Item.
5. Rotate the DIAL knob to select the desired interval. Available selections are “
5MIN
”
through “
60MIN
” (
5MIN
increment) or “
OFF
”.
6. Now, press the [ VOL/SEL
] key to save the new setting and exit to Clock/Timer mode.
To disable the interval timer, just repeat the above procedure, rotating the
DIAL
knob to
select “
OFF
” in step 5 above.
M
ISCELLANEOUS
S
ETTING