(1)
Make sure the transceiver is off. Remove the
hard or soft case, if used, and remove the battery
pack. Disconnect the antenna from the top panel.
(2)
Pull off the three knobs on the top panel, and
remove the
EAR/MIC
gasket from the antenna
jack. Then remove the screw affixing the top
panel and carefully remove it and the rubber
gasket underneath.
(3)
Remove the four screws in the battery spring.
plate on the bottom of the transceiver, and care
fully remove the plate and battery latch button.
( 4)
On either side of the rear panel, remove the
screw affixing the front and rear halves of the
case. Tilt the rear panel outwards slightly at the
bottom, and remove the top panel. Then gently
separate the front and rear panels from the chas
sis.
-
3
-
(5)
Lift the EEPROM Unit (or Matrix Unit) from
the rear side of the chassis to remove it.
