Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT..., Operation Manual

Page: 43 / 180

Page 41 FT
DX
9000MP O
PERATION
M
ANUAL
FPS-9000H R FPS-9000H R
FPS-9000H R FPS-9000H R FPS-9000H R
EAR EAR
EAR EAR
EAR
P P P P P
ANEL ANEL
ANEL ANEL
ANEL
Cooling Fan
This cooling fan provides ventilation for the power
supply circuitry. When the main power switch is turned
on, the fan will be engaged.
AUDIO Jack
INPUT A
This jack connects to the FT
DX
9000MP ’s EXT
SPKR A jack.
The INPUT A terminal accepts audio input from
the transceiver's Main (VFO-A) receiver.
When the cable from INPUT A is connected to the
radio’s EXT SPKR A jack, the internal “A” speaker
in the transceiver will be cut off automatically.
This jack is gold-plated, for high performance.
INPUT B
This jack connects to the FT
DX
9000MP ’s EXT
SPKR B jack.
The INPUT B terminal accepts audio input from
the transceiver’s Main (VFO-B) receiver.
When the cable from INPUT B is connected to the
radio’s EXT SPKR A jack, the internal “B” speaker
in the transceiver will be cut off automatically.
This jack is gold-plated, for high performance.
OUTPUT
This is an audio output terminal that may be used
for tape recordings and other purposes.
The audio delivered from the OUTPUT jack is af-
fected by the high- and low-cut filters, and while
the audio normally is mixed (VFO-A/B), the
[
MUTE
] switches on the front panel allow you to
disable either the “A” or “B” receiver, so that only
one receiver's audio is passed to the OUTPUT jack.
Because the audio at the OUTPUT jack is affected
by the transceiver’s [
AF GAIN
] control, you can
use that control to set the optimum audio output
level for the intended purpose.
This jack is gold-plated, for high performance.
BREAKER Switch
The circuit breaker will trip automatically if an over-
current or other potentially-dangerous anomaly is de-
tected.
A A A A A
D D D D DVICE VICE VICE VICE VICE
:
If the breaker trips, please inspect the transceiver and
power supply to see if the problem can be found. Once
you are satisfied that nothing obvious is wrong, push
the breaker switch in until you hear a “click.” This
will reset the breaker.
AC Power Cable (Input)
This is the input port for AC voltage. The FPS-9000H
uses a “universal” input from 100 to 240 Volts AC.
Power consumption is as described below:
AC Input voltage: AC100 ~ 240V (50-60Hz)
Current Consumption: 13.2A ~ 5.2A
DC Power Cable (Output)
This is the DC output cable from the power supply,
and it should be connected to the appropriate jack on
the rear panel of the
FT
DX
9000MP . The DC output
is as described below:
50 Volt, 24 Amps (MAX)
13.8 Volt, 5 Amps (MAX)
5 Volt, 7 Amps (MAX)
N N N N N
O O O O OTE TE TE TE TE
:
Please be sure that both the transceiver’s front panel
[
POWER
] switch and the
FPS-9000H ’s main power
switch are both turned off any time you plug in or
unplug any power cable to/from the
FPS-9000H . This
will avoid the possibility of possibly-damaging spikes
and/or electrical shock.