Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT..., Operation Manual

Page: 153 / 180

Page 151 FT
DX
9000MP O
PERATION
M
ANUAL
MMMMM
ENU ENU
ENU ENU ENU
M M M M M
ODE ODE
ODE ODE ODE
044. MIC SCAN
Function : Enables/disables scanning access via the
microphone’s [ UP
]/[
DWN
] keys (only available at the
rear panel’s MIC Jack).
Available Values : ENABLE/DISABLE
Default Setting : ENABLE
045. MIC SCAN RESUME
Function : Selects the Scan Resume mode.
Available Values: PAUSE/TIME
Default Setting : TIME
PAUSE: The scanner will hold until the signal disap-
pears, then will resume after one second.
TIME: The scanner will hold for five seconds, then
resume whether or not the other station is
still transmitting.
046. AF/RF DIAL SWAP
Function : Reverses the functions of the [ AF GAIN
]
(VFO-B) and [ RF GAIN
] (VFO-A) knobs.
Available Values : NORMAL/SWAP
Default Setting : NORMAL
When this menu is set to “SWAP,” you may adjust the
Sub (VFO-B) receiver audio using the large [
RF GAIN
]
(VFO-A) knob and adjust the Main (VFO-A) receiver
RF gain using the small [
AF GAIN
] (VFO-B) knob.
This puts both “Volume” controls on the same shaft.
MODE-AM G
ROUP
047. AM MIC GAIN
Function : Sets the microphone gain for the AM mode.
Available Values : MCVR/0 ~ 255 (FIX)
Default Setting : 160
When this menu is set to “MCVR,” you may adjust
the microphone gain using the front panel’s
MIC knob.
048. AM MIC SELECT
Function : Selects the microphone to be used on the
AM mode.
Available Values : FRONT/REAR/DATA/PC
Default Setting : FRONT
FRONT: Selects the microphone connected to the
front panel’s MIC jack while using the AM
mode.
REAR: Selects the microphone connected to the
rear panel’s MIC jack while using the AM
mode.
DATA: Selects the microphone connected to pin 1
of the
PACKET Jack while using the AM
mode.
PC: Selects the microphone connected to the
rear panel’s
AUDIO IN 3.5-mm jack while
using the AM mode.
GENERAL G
ROUP