Yaesu FT-950, Technical Supplement

Page: 28 / 154

ALIGNMENT-14
Alignment
FT-950 Technical Supplement
ˆ
Perform the same procedures for the Alignment
Menus “J-04 P50” through “J-15 P05”, “K-01 P1h”
through “K-15 P05”, “L-01 P1h” through “L-15
P05” per the chart at the right.
ˆ
Press the [ENT] key to save the new setting at 1.8
MHz, 3.5 MHz, 7 MHz, and 10 MHz Bands.
ˆ
Perform the same procedures for the Alignment
Menus “N-01 P1h” through “N-15 P05” per the
chart at the right.
ˆ
Press the [ENT] key to save the new setting at 14
MHz, 18 MHz, and 21 MHz Bands.
ˆ
Perform the same procedures for the Alignment
Menus “Q-01 P1h” through “Q-15 P05” per the
chart at the right.
ˆ
Press the [ENT] key to save the new setting at 24
MHz and 28 MHz Bands.
ˆ
Perform the same procedures for the Alignment
Menus “S-01 P1h” through “S-15 P05” per the
chart below.
ˆ
Press and hold in the [MENU] button for one sec-
ond to save the new settings and exit the align-
ment mode.
AM-TXG Adjustment
ˆ
Connect the 50-Ohm Dummy Load and Wattme-
ter to the “ANT 1” jack.
ˆ
Set the value of Menu item “111 TGEN TX PWR”
to “100”, and Menu item “112 TGEN AM CAR”
to “100”.
ˆ
Set the VFO-A frequency to 14.200 MHz in the
AM mode.
ˆ
Press and hold in the [1.8(1)], [3.5(2)], and [7(3)]
keys, while turning the radio on, to enter the
alignment mode.
ˆ
Rotate the Main Tuning Dial knob to select the
alignment parameter “T-02 tCA.”
ˆ
Rotate the [CLAR(VFO-B)] knob so that the
Multi-Display Window shows “0”.
ˆ
Press the PTT button without microphone input,
then rotate the [CLAR(VFO-B)] knob for 70 W
(±5 W) on the Wattmeter.
ˆ
Release the PTT button.
ˆ
Press and hold in the [MENU] button for one sec-
ond to save the new setting and exit the align-
ment mode.
REV-ALC Adjustment
ˆ
Disconnect the test equipment from the “ANT 1”
jack.
ˆ
Press and hold in the [1.8(1)], [3.5(2)], and [7(3)]
keys, while turning the radio on, to enter the
alignment mode.
ˆ
Rotate the Main Tuning Dial knob to select the
alignment parameter “U-01 rAC.”
ˆ
P r e s s t h e P T T b u t t o n , t h e n r o t a t e t h e
[CLAR(VFO-B)] knob so that the PO meter turns
on 14 dots.
ˆ
Release the PTT button, then press the [ENT] key.
ˆ
Press and hold in the [MENU] button for one sec-
ond to save the new setting and exit the align-
ment mode.