Ver. 0112 MAIN CPU implements improvements (also includes all previous updates):
•
The FH-2
[
<-
][
->
]
keys are made to increment the frequency at 100kHz up or down.
•
Correct the CW Auto Mode.
•
DMU Band scope Display Signal Peak Frequency is centered.
Ver. 11.53 EDSP implements improvements (also includes all previous updates):
•
The DNR algorithm is not reset between TX/RX, to eliminate the increased receive noise after a
transmission.
•
Increase the response of the compression level meter in conjunction with the PROC knob. (Max
up to 12dB).
NOTES:
*Rotate the [METER] switch to select “COM” (Compression). We recommend setting the PROC level within the 5dB
to 10dB range.
*When menu settings are saved on the DMU-2000 CF card and transferred to the new version, some previous versions
may not transfer correctly. Please check your menu, update the settings, and then save the new settings to the CF card.
MAIN CPU
*Don't forget to write down (or save to a CF Card) any personal menu settings you have changed from the
default before you start. Please see the DMU-2000 Data Management Operation Manual for the procedure
to save your settings to a CF card.
1.
Turn the FT
-
950 OFF and disconnect the DC power cable (or turn OFF the power supply for FT
-
950 and wait a minute, until the capacitors discharge).
2.
Locate the program switch thru the access hole on the back at the rear right corner of the radio.
Carefully move the
PGM-SW
to the
RIGHT
(program position).
3.
Connect the serial straight through programming cable, DB9F to DB9F, connector to the serial
port COM1 in the back of your computer. Plug the DB9F connector to the CAT connector on the
FT
-
950. If you use a USB to serial adapter, you might need to change the COM Port number.
4.
Leave the FT
-
950 turned OFF and connect the DC power cable (or turn ON the power supply for
FT
-
950).
5.
Now go to the desktop open PEP950_MAIN folder and find the
FSW005
icon as shown below.
Double-click
the FSW005
icon, displayed on the Program Screen.
Carefully move the PGM-SW to
the
RIGHT
(program position).
