![background image](http://html2.mh-extra.com/html/yaesu/ft-65r/ft-65r_operating-manual_3131047038.webp)
VFO Scanning
The
FT-65R/E
provides two VFO scanning functions: “Manual VFO Scan-
ning” and “Programmed Mode (VFO) Scanning.”
Manual VFO Scan
1. If necessary, press the [
V/M
] key to change to the VFO mode.
2.
Press and hold the [▲] or [▼] key to initiate upward or downward scanning,
respectively.
3. When scanning encounters a signal strong enough to open the squelch,
the scanner will halt temporarily; the decimal point of the frequency display
will blink to indicate this “Resuming” condition.
4. The scanning will resume according to the Scan-Resume mode selected in
the Set Mode Item “
25:RESUME
”.
5. To cancel scanning, press the
PTT
switch,
[▲] or [▼
] key.
Programmed Mode (VFO) Scan
1. Press and hold the [
#BAND
] key.
2.
Press the [▲] or [▼] key to select the band
-
width for Programmed Mode (VFO) scanner.
Available selections are +-1 MHz, +-2 MHz, +-5 MHz, ALL, PMS-X, and
BAND.
Display
Description
BAND
(default setting)
The scanner will sweep frequencies on the current op-
erating band.
+-1MHz
The scanner will sweep ±1 MHz from the operating fre-
quency.
+-2MHz
The scanner will sweep ±2 MHz from the operating fre-
quency.
+-5MHz
The scanner will sweep ±5 MHz from the operating fre-
quency.
ALL
The scanner will sweep all frequencies.
PMS-X
The scanner will sweep frequencies designated by the
currently selected PMS (Programmable Memory Scan)
frequency pair.
PMS-X
will appear in the [
#BAND
] selections after setting a
PMS frequency pair.
36
Scanning
FT-65R/FT-65E Operating Manual