YAESU HF/50 mHz Transceiver FT-450 User’s Manual
- 18 -
NAME
BUTTON
FUNCTION
MTR
MTR/DIM
Change the meter function in the transmit mode
RCL
RCL
Recall the quick memory bank memory
Table 11 – 22 Duplicate Button Functions
NAME
DIAL
FUNCTION
DOWN
DSP/SEL to left
Decreases the VFO frequency or memory selection by 1 step
UP
DSP/SEL to right
Increases the VFO frequency or memory selection by 1 step
N/A
-
No function – disables the button
USER
-
For future expansion – do not select
Table 12 – Miscellaneous redundant or useless function
7
Adaptation (Menu)
If you t-press the “F
■
” button, the display will show the word MENU to the right of the frequency
readout. Below the word MENU is the name of one of 62 adaptable parameters. You may then sequence
through the parameter names by turning the “DSP/SEL” knob. When you find the desired parameter,
press the “DSP SEL” knob. The word MENU will then blink and the lower right now shows the current
value of the parameter. With most parameters, you then turn the “DSP SEL” until the desired value is
displayed. In most cases, pressing the “HOME/RCL” button will restore the factory default.Then press
the “DSP SEL” button again to stop the MENU blinking. When you are done changing parameters, t-
press the “F
■
” button to exit MENU operations.
There are 7 exceptions to the above procedure. The exceptions are BCN TXT, BEEP VOL, CWSPEED,
CWSTONE, MEMTAG, MY BAND, and MY MODE. The procedures for those exceptions will be
discussed later in this section
EXT MENU - When EXT MENU is turned off, only the 16 most used parameters are presented. The
parameter names are in alphabetical order (except EXT MENU) in a continuous loop to expedite finding
the right parameter. Since you may have to extend the menu to all 62 parameters, EXT MENU is place
before the alphabet and a beep sounds when it is selected.
ID
NAME
FUNCTION
DEFAULT
VALUES
001* EXT MNU
Extension menu
OFF
ON / OFF
002 A&F DIAL
AM & FM dial
DISABLE
DISABLE / ENABLE
003 APO
APO time
OFF
OFF / 1~12 h
004 BCN TIM
Beacon time
OFF
OFF / 1~255 sec
005 BCN TXT
Beacon text
-
-
006 BEEPTON
Beep tone
880 Hz
440 / 880 / 1760 Hz
007* BEEPVOL
Beep volume
000~100 (FIX ), or 101~201 (LNK –50 ~ +50)
008 CAT RTS
Comp Aided Trans
ENABLE
DISABLE / ENABLE
009 CAT TOT
CAT time out time
10
10, 100, 1000, 3000 ms