Yaesu FT-1907R, Operating Manual

Page: 41 / 88

37 FT-1907R O
PERATING
M
ANUAL
M
EMORY
O
PERATION
M
EMORY
B
ANK
O
PERATION
The large number of memories available in the FT-1907R could be difficult to utilize
without some means of organizing them. Fortunately, the
FT-1907R
includes provision for
dividing the memories into as many as eight Memory Banks, so you can categorize the
memories in a manner convenient to you. You may enter and exit the “Memory Bank”
mode by a single press of the Microphone’s [
] key, as we shall see below.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory
Bank.
2. Press and hold in the [
D/MR
(
MW
)] key for one second, then rotate the
DIAL
knob to
select the Memory Bank number (“ b1 ” ~ “ b8 ”) you want as
the Memory Bank for this channel. The Memory Bank num-
bers are found by rotating the
DIAL knob counter-clockwise past memory channel “0.”
3. Press the [ D/MR
(
MW
)] key momentarily to copy the memory channel data into the Memory
Bank.
1) You may assign one memory channel into several Memory Banks.
2) The PMS memory channels (L0/U0 through L9/U9) may not be assigned to a
Memory Bank.
Memory Bank Recall
1. Press the [
D/MR
(
MW
)] key, if needed, to enter the Memory
mode.
2. Press the Microphone’s [
] key to activate the “Memory
Bank” mode. The Memory Bank number will appear on
the display.
3. Press the [ #
] key to increment the Memory Bank (“
b1 ”
through “
b8
”).
4. Rotate the DIAL knob to select the memories within the
selected Bank; you will observe that you can only select memory channels in the current
memory bank. The small memory bank number will appear, to the right of the fre-
quency display, two seconds after you complete memory channel selection while oper-
ating within a Memory Bank.
5. To change to another Memory Bank, press the [
#
] key to
step up to the next-highest bank.
6. To exit from Memory Bank operation, just press the Microphone’s [
] key. The Memory
Channel number will appear steadily on the right side of the display, indicating that you are
now in the “standard” Memory Recall mode, without utiliza-
tion of the Memory Banks. The memories stored in the vari-
ous Banks will remain in those banks, however; you do not need to store them again.