69
FT-1900R O
PERATING
M
ANUAL
The
FT-1900R
includes a convenient “Clone” feature, which allows the memory and con-
figuration data from one transceiver to be transferred to another
FT-1900R
. This can be
particularly useful when configuring a number of transceivers for a public service opera-
tion. Here is the procedure for Cloning one radio’s data to another:
1. Turn both radios off.
2. Connect the user-constructed cloning cable between the
MIC
jacks of the two radios.
3. Press and hold in the [
LOW
(
A/N
)] key while turning the radios on. Do this for both
radios (the order of switch-on does not matter). “
CLONE
” will appear on the displays of
both radios when the Clone mode is successfully activated
in this step.
4. On the
Destination radio
, press the [
D/MR
(
MW
)] key
(“
- -WAIT- -
” will appear on the LCD).
5. Press the [
MHz
(
SET
)] key on the
Source radio
; “
- - - -TX- - - -
” will appear on the Source
radio, and the data from this radio will be transferred to the
other radio.
6. If there is a problem during the cloning process, “
ERROR
”
will be displayed. Check your cable connections and bat-
tery voltage, and try again.
7. If the data transfer is successful, “
CLONE
” will appear on both displays.
8. Press any key to exit to normal operation.
9. Turn both radios off and disconnect the cloning cable.
C
LONING
Pin 6: PTT/CLONE
Pin 6: PTT/CLONE
Pin 4: GND
Pin 4: GND
RJ12/6
6 Position 6 Contact
Modular Plug
RJ12/6
6 Position 6 Contact
Modular Plug