
10
2. Set up Operation Mode
When the Power Switch is turned ON, Operation Mode screen appears.
This screen is for normal operation.
The DR-1X could be
set up with two frequencies for the uplink and the downlink and also different operation
modes for each frequency.
REMOTE
TX (downlink)
RX (uplink)
To receive Analog FM and Digital C4FM signals simultaneously, set RX to
[AUTO] mode.
This mode may activate the AMS (Automatic Mode Select) function, then receive (uplink) and transmit
(downlink) signals of the Analog FM and Digital C4FM. The default setting is [AUTO].
If operating the repeater using the DG-ID, select the
[NORMAL] in the [
FIX
] mode.
The DG-ID function is not
available because the Analog FM mode does not include the DG-ID information.
In the C4FM digital mode, three digital modes are recognized automatically. In normal C4FM digital, it will be
in V/D mode.
Touch [AUTO] or [
FIX
] in the operation mode screen area to set the operating mode.
[
AUTO
] Touch here to activate the AMS function. The mode switches automatically according to the
received/transmitted signal types. [AUTO] is turned red, [NORMAL] automatically light up.
[
FIX
]
Touch here to activate the FIX mode.
[
FIX
] is turned yellow.
Note that when selecting the [FIX]
mode, that other mode signals may not be received.
Either [VOICE WIDE] or [DATA] modes are automatically recognized in the C4FM uplink Signal, and receive
mode is changed to fit the signals, so no setting is necessary.
[
NORMAL
]
Normal C4FM digital mode
[
VOICE WIDE
]
High-rate voice C4FM digital mode
[
DATA
]
H
igh-speed data C4FM digital mode
[
FM
]
Analog FM communication mode
RX
indicator
This indicator shows green when a signal is received and white when there is no signal.
TX
indicator
This indicator shows red when the repeater transmits and white when there is no transmit.
[
REMOTE
] Displayed in red when remote operation with an external controller is enabled (see page 33).
[
SETUP
]
Touch here to switch the display to set up the frequency.