— 15 —
IV.1.2 Connection to EGC Engines (Gasoline, 2005 and Later)
Note: If an EVC system is fitted, see the EVC section details
.
The Device is compatible with all EGC engines (8.1Gi-H, 8.1GXi-G, 8.1OSi-D and many other).
Device is connecting to EVC/Vodia 8-pin Deutsch connector with adaptor cable (see Appendix F, available
in accessories at ordering page). The cable has male and female connectors both (Y-connector), so you can
use diagnostics equipment with Gateway connected.
Note: you can use supplied 6-pin plug as a dust cap for the free Device connector.
IV.1.3 Connection to EDC III (EMS2), EDC IV (Diesel)
Note: If an EVC system is fitted, see the EVC section details.
To connect with EDC III (EMS2) engines, an EVC/Vodia 8-pin adaptor cable (see Appendix F, available
in accessories on the ordering page) is required. The adaptor cable must be connected to the engine’s 8-pin
Deutsch connector, or in line (cable has a built-in Y-connector) between the ECU (Engine Control Unit)
and the CIU (Control Interface Unit).
The Gateway is compatible with EDC IV engines, but the wiring may differ depending
on the instruments installed. A 6-pin Deutsch Vodia connector usually has four wires (power and J1708) only
and cannot be used for a Gateway connection. Please refer your installation diagram and follow
the instructions from section IV.3.
For EDC I and EDC II engines, please, use another our product, J1708 Engine Gateway YDES-04 (see
for details).
IV.1.4 Connection to EVC-A MC (EVC-MC, EVCmc) Engines (2004-2006,
Diesel and Gasoline)
Unlike other EVC engines, EVC-A MC (used in the D3-160A-A engine and some others engines) use
the Volcano protocol which is physically compatible with the J1939 protocol, but differs at the software