The green light is always on
The red light flashes slowly
The red LED flashes quickly
The green light flashes slowly
1.battery clamp is reversely connected
--- check whether the clip is reversely
connected
2.The clamp is short-circuited
---check whether two clamps together
connect or connect both cable clamps to the
same piece of metal
Back change protection, the voltage of the
car battery is higher than 12.6V
-No jump starter needed, the car battery is
enough to star your car
The temperature of the clamp exceeds
65(+/-5)degrees
--- remove the clamp untill the red green led
flash
The vollage of the starter is too low
--try to replace the startup power supply or
change it in time
Charge your Car Battery
1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles,or it will cause serious damages to the unit.
4. Do not jump start your car when the battery capacity is lower than 50%.
5. Do not connect two clamps together when the starter is powered on. And
do not connect both cable clamps to the same piece of metal.
6. If the engine does not start on the first try, disconnect it from the car
battery and wait for at least 20 seconds before reconnecting. Maximize
three attempts in two minutes.
7. Once the engine is successfully started, disconnect the clamps within 30
seconds.
EN
06
Summary of Contents for YA10
Page 1: ...support yaberauto com User Manual Car Battery Jump Starter...
Page 10: ......
