— 2 —
6
.
Test
When
finished
in
the
factory
,
has
build
-
in
batteries
.
Before
testing
,
we
will
need
to
code
wireless
products
with
,
for
the
coding
details
,
please
view
the
CODE
SETTING
of
the
manual
of
wireless
products
.
The
testing
process
as
following
:
1
.
Keep
the
distance
of
YP
A
RE01
from
the
wireless
products
above
3
meters
;
press
the
key
with
lock
picture
one
the
remote
controller
for
1
second
.
2
.
Confirm
the
wireless
products
have
the
same
response
,
such
as
hear
the
hint
voice
.
3
.
Operate
in
the
corner
of
covered
zone
of
wireless
products
,
such
as
the
place
blocked
by
wall
and
large
object
,
to
see
if
the
system
has
the
same
hint
voice
.
YPARE01
YPARE01
8.System limited
Our wireless products are reliable,while in certain situation,our system will be limited,the situation can be some
one as below:
1. The receiver signal is blocked or does not match the frequency of the remote control.
2. There is the same frequency interference.
3. The voltage of panel is unstable or the receiving distance is too large.
Note: If the unauthorized operation by the customer cause the problem, our company is not responsible.
7.Change batteries
The batteries should be changed every year,or the signal may fade in the process of transmitting.The batteries
should be 1 piece of CR2450 button battery,please follow the below steps to change the batteries.
1. Use your hand to pry the back cover at the opening on the left lower side of the front of the remote control.
2.Fetch the back cover and pull out the old batteries.
3.Input the new batteries,pay attention to the anode and cathode.
4.Fix the back cover.
5.Test the installed batteries:press any key,the LED lamp on the remote controller lighting.
positive
electrode
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help .
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC WARNING
