Revision 1.01
WebRelay-10
TM
Users Manual
2.3.3 Open Configuration Web Page
Once the network is set up, open the configuration setup page by typing the following URL into the browser:
http://192.168.1.2/setup.html (note that if option 1 above was used for initial configuration, replace the IP
address given here with the newly assigned IP address). A password is required to change any parameters.
The default password is ‘webrelay’ (do not include quotes, password is case sensitive).
2.4 Web-Based Setup
WebRelay-10
TM
is fully configurable through HTML 4.0 compliant web browsers such as Internet Explorer and
Mozilla Firefox. It’s easy to use tab based menu system has been designed to allow the unit to be configured easily.
Note that in this chapter, the default IP address of 192.168.1.2 is used in all examples. If the IP address has been
changed, substitute the new IP address for the address shown in the examples.
Before proceeding, make sure a network connection has been established between the computer and WebRelay-10
TM
.
This is done by typing the following URL into the web browser: http://192.168.1.2/setup.html. Another way to
check communications is to ping WebRelay-10
TM
(from the command prompt (type ping 192.168.1.2)). Each setup
page is described below.
2.4.1 Main Setup Page
This is the initial page that appears when the URL http://192.168.1.2/setup.html is entered into the web
browser. It provides basic information about the WebRelay-10
TM
unit.
Xytronix Research & Design, Inc.
page 12
