8
Example for temperature correction: The current set temperature value is 300
℃,
however, the
actual temperature is only 290
℃
. So it needs to correct by +10
℃
. Correction method: if the
current correction value is 00 or -00; then change it to 10. If the current correction value is -20,
then change it to -10. If the current correction value is 20, then change it to 30.
5.
Sleep Mode Set:
Press “SET” key one time when the LED displays “F-3” and flashes, the unit enters the Sleep
mode status. At this moment, the LED displays the pre-set value. Press “▲” or “▼” key to
change the set value. If set value reads “000” that means the unit set in “Sleep” mode releasing
status. If the display read “100” that means the unit set in “Sleep” mode. Press “SET” key once
to finish the sleep mode setting, then the unit automatically backup. The user may continue set
other modes or back from current set mode.
Please note the manufacturer original design will keep in “Free” status without setting
“Sleep” mode.
6.
Wake-up method:
①
Temperature Down Suspend: If the unit is set at Sleep mode function, after 20min
idleness, the system will enter the sleep mode automatically, the temperature of soldering will go
down to 150
℃
(302
℉)
/ and the LED displays at “ 150” and flashes
,
the temperature of
desoldering will go down to 200
℃
(392
℉)
and the LED displays at “ 200” and flashes
.
Activating the solder wand will disengage the suspend status and the unit will immediately ramp
up to the preset temperature.
There are three methods to wake-up the Temperature Down Suspend.
a
.Ⅰ
Soldering: Pick up the solder wand 210ESD and shake it gently.
Ⅱ
Desoldering: Pick up the solder wand and press the red suction button on the
DIA 100.
b. Press any key of the unit.
c. Turn off the main switch and restart.
○
2
Power off Suspend: If the unit enters the Sleep mode over 40min without wake-up, the unit will
enter automatically the power off suspend status. It means the heater power will be cut off and
the LED displays “— — —” and flashes. You can wake it up by pressing “
▼
” key when you
reuse the iron or turn off the main switch and re-switch on.
7.
Fahrenheit and Centigrade (Celsius) temperature selection
When temperature display window shows "F-4" and blinking, press the "SET" button, at this
time ,the system enters the degrees Fahrenheit and Centigrade temperature selection function,
indicating the temperature of the window shows the current status. Press "▲" or "▼" key to
change the temperature selection status. It expressed as degrees Celsius temperature value if set
to “
℃”
; it shows as degrees Fahrenheit temperature if set to
℉
WORKING TEMPERATURE
SOLDERING
To meet RoHS requirements, the common 60/40 lead solder alloys are not allowed in