11
1.
Ensure that the working voltage matches your power supply before beginning use.
2.
Check carefully for any damage during transportation.
3.
This unit contains:
A: DIA100: Desoldering iron assembly with tip.
B: 307A: Soldering iron assembly with tip..
C: AC Power cord with plug.
D:Hot air gun
E:Accessories included:
a.
Two cleaning brushes
b.
One cooling strip
c.
One 0.7
∮
probe
d.
4pcs nozzles
e.
Two iron holders
f.
Hot air gun holder
Optional parts:
A) TWZ90: 32V/90W Tweezers can be interchangeable with soldering iron.
B) HAP80: 32V/80W Hot air blow pencil can be interchangeable with DIA100.
OPERATING PROCEDURES
Caution:
Check carefully for any damage during transportation and ensure that the working voltage
matches your power supply before plugging in the station.
1.
Ensure that the base unit’s power switch is in the ‘OFF” position.
2.
Plug in “Solder and Desolder” wands, connect “Vacuum tube” to “VAC”. Put the hot air gun to
the (holder)
3.
Connect AC power cord to mains “In-Let”.
4.
Turn switch “ POWER SWITCH” to “ON” position
and the switch led will be light.
5.
All of the functions ( Soldering ,Desoldering,Hot air gun )will work at the same time after
turning the power switch , and then the corresponding temperature LED or wind LED display
will be ON and show the value.
6.
Users can turn off the the Soldering function or Desoldering function by pressing the
key”SET+UP” ,then the corresponding LED display will show “_ _ _”.
NOTE: It means that the corresponding heater power is cut off.At this time ,the users can only
use the hot air function.
Pressing on the “
▲”on can reuse the corresponding function.
A: Soldering function / Desoldering function option
1) Press the “▲” key up until the temperature to 250
℃
(482
℉
)
(If set to degrees Centigrade, the
temperature display window of the upper right corner shows
℃
, if set to degrees Fahrenheit, the
temperature display window of the upper right corner shows
℉
).
