Installation
MIQ/CHV PLUS
12
ba75539d03
03/2018
3.4
Connecting the valve control line
General instal-
lation instructions
Observe the following instructions when attaching connecting wires to the termi-
nal strip:
Shorten all the wires used to the length required for the installation.
Basically, fit all stranded wire ends with wire end sleeves before connecting
them to the terminal strip.
Any wires that are not used and project into the housing must be cut off as
closely as possible to the cable gland.
Materials required
Wire end sleeves, suitable for the connecting wires, with suitable crimping
tool
1 x cable gland with sealing ring (scope of delivery MIQ/CHV PLUS)
Tools
Cable stripping knife
Wire stripper
Phillips screw driver
Small screw driver
The valve control line must be connected if the valve is not
controlled via the IQ S
ENSOR
N
ET
system.
WARNING
Danger of injury from lines that are under pressure. Before
opening the compressed air line, ensure that the section
of line concerned is free of pressure. The compressed air
glands in the housing may only be opened by a service
technician authorized by WTW.
All manuals and user guides at all-guides.com
