Seite 76 von 170 Artikel Nr.: 1080622001 Stand: 2022_06_24 Technische Änderungen und Irrtümer vorbehalten.
Installation and Operating Instructions
Heat Meter Calculator
Heat/Cooling Meter Calculator
Cooling Meter Calculator
PolluTherm F
DE-18-MI004-PTB037 (MID heat)
DE-18-M-PTB-0049 (national German cooling)
CH-T2-18769-00 (national Swiss cooling)
1
Application and Function
The calculator SensoStar C is designed for the measurement of the consumed energy in a closed heating, cooling or
heating/cooling system.
2
Contents of the Package
-
Calculator
-
Installation kit
-
Installation and Operating Instructionscontaining Operating Instructions „Communication Interfaces POLLUSTAT(C)“
(with meters with an optional interface), Declaration of Conformity
3
Information
3.1
General Information
-
Valid standards for the application of calculators for heat metering: EN 1434, parts 1 – 6; the Measuring Instruments
Directive 2014/32/EU, Annexes I and MI-004; and the relevant national verification regulations.
-
For the selection, installation, commissioning, monitoring and maintenance of the instrument observe the standard
EN 1434 part 6, as well as the verification regulations PTB TR K8 + K9 for Germany (and any relevant national
verification regulations in other countries).
-
The measuring stability of the meters is only given if the water quality complies with the conditions of CEN report TR
16911 and VDI 2035.
-
National regulations for the consumption measurement of cooling must be observed.
-
The technical regulations for electrical installations must be observed.
-
This product fulfils the requirements of the European Council Directive on Electromagnetic Compatibility (EMC
Directive) 2014/30/EU.
-
The identification plate of the instrument and the seals must not be removed or damaged – otherwise the guarantee
and the approved application of the instrument are no longer valid!
-
The calculator left the factory in conformance with all applicable safety regulations. All maintenance and repair work
is to be carried out only by qualified and authorized technical personnel.
-
The correct installation point in the system must be chosen: inlet or outlet flow (see item 3.1 ’Pictograms installation
point’).
-
To clean the calculator (only if necessary) use a slightly moist cloth.
-
To protect against damage and dirt the calculator should only be removed from the packaging directly before
installation.
-
All specifications and instructions listed on the data sheet and in the Application Notes must be adhered to. Further
information can be obtained at
www.sensus.com | www.xylem.com
.
-
Instruments which have been replaced or exchanged must be disposed of according to relevant environmental
regulations; the battery must be disposed of in an environmentally friendly manner as special waste.
-
The display is deactivated and can be activated for two minutes by pushing the button.
-
Unit of energy and installation point (outlet flow / inlet flow) can be set on location, only once, before start of
operation by pushing the button or alternatively using the „Device Monitor“ software.
-
Type and concentration of glycol in the medium of those calculator types designed to be used with glycol can be set
on location at any time using the „Device Monitor“ software (see item 8.1 for details).
EN
