12
INSTALLATION
Ventilation
Ventilation
This can be mounted on the upper part of one
of the two flat pieces
1. Drill a hole of the same dimensions as your
ventilation pipe.
2. Connect the ventilation duct using a gasket
(equipment not provided) (fig 6)
Note:
Ventilation duct and electrical connections
must be installed inside separate sheaths
The gasket
The access point cover gasket is made of foam,
with a self-adhesive rectangular section.
This gasket is mounted fixed to the lower part of
the access point cover.
Tightness is achieved when the access point
cover is clamped over the tank.
Ensure a minimum of two full turns in order to
achieve perfect tightness.
Riser
The riser is screwed on the upper part of the
tank in the place normally occupied by the
cover. The cover is then screwed to the upper
part of the riser
Up to two may be fitted (Fig. 8)
Figure 5. Angular position of hook on riser.
Ground rod and earth strap (optional)
Hook the earth strap between the guide bar support
and the cross beam
Pump Installation
Refer to instructions supplied with the pump.
Check the direction of the pump’s rotation
before the pump is installed in the pumpstation.
WARNING!
Before installing the pump
or pumps, remove any
earth or gravel which may
have fallen into the tank.
Tank
Gasket
Fig. 6
Fig. 7 Gasket position
Access point cover
Fig. 8
