63
9.31
Operating Hours
OPPERATING HOURS
0000 h.
Total time the HYDROVAR is connected to the power
supply. Reset: press
Ï
and
Ð
together, till
“TIMER-RESET” appears.
In parallel, the TOTAL RUN TIME of the motor, in the main menu would be reset.
Press the
¾
button to change to the next parameter
9.32
Display – Contrast
DISP. CONTRAST
50 %
Can be adjusted between 10 and 100% for improved
clarity of the display, depending on the installation
position.
Press the
¾
button to change to the next parameter
9.33
Set Password
SET PASSWORD
0066
The pre-set password (0066) can be changed if necessary.
Set Password by pressing
Ï
or
Ð
If the password will be modified, it is recommended to make some notes about the new
password.
Press the
¾
button to change to the next parameter
9.34
Lock Function
LOCK FUNCTION
OFF
Possible settings with
Ï
or
Ð
OFF: All parameters in the main menu can be changed without the need of a password.
ON: If the LOCK FUNCTION is activated, it’s not possible to make any changes in the main
menu. The HYDROVAR can be just started or stopped by using the buttons
Ï
and
Ð
.
In order to change the set value, the LOCK FUNCTION must be reset to OFF.
Press the
¾
button to change to the next parameter
9.35
Internal Heater
HEATING
ON
Internal heating during standstill to prevent
condensation in the HYDROVAR
If “ON” is selected
(should be the general configuration)
a heating resistance
(approx. 10 watt) is switched on, when the motor is at a standstill and the supply of the
HYDROVAR is O.K.
Notice: If the HYDROVAR is cut from the supply the internal heater doesn’t work!
So if the HYDROVAR isn’t used for a longer time (e.g. winter season) it shouldn’t be
disconnected from the power-supply.
Press the
¾
button to change to the next parameter
