5
The 02095 Series syrup “Sold-Out” Switch automatically shuts off an electric dispensing
valve when syrup is sold out and turns on “Sold-Out” light. This prevents the operator
from selling a drink of carbonated water only, with no syrup. The switch automatically
resets when the empty Bag-In-Box is replaced and syrup line pressure is restored.
Note:
This switch is designed for use with Bag-In-Box systems only, NOT transfer tanks.
PLUMBING
− Refer to Diagram A
1. Shut off gas supply to syrup pump.
2. Open dispensing valve to relieve all syrup line pressure.
3. Install barbed switch into syrup line near dispensing valve and securely clamp
both sides.
4. Switch may be mounted in any position in syrup line.
FOR ELECTRICAL DISPENSING VALVES
Reference image on page 2
ELECTRICAL
− Refer to Diagram B
1. Disconnect power.
2. Select location for LED “Sold-Out” light facing operator. (Light intensity is very
limited when viewed from side.) Preferred location is on front surface of valve
cover as shown. (Diagram B).
3. Drill 1/4” (6.3 mm) hole. slide LED lens into hole from front of valve. Next feed
LED light through hole from inside or back, slip LED light into lens making sure
fingers of lens snap into place.
4. Place sold out label next to light.
5. REFER TO DIAGRAM C - Locate the 24 VAC leads running up the tower to the
dispensing valve switch and solenoid. Cut one wire (the black wire if they are
colored white and black). On the end going up the tower connect the gray wire
from the “Sold Out” switch. Then on the end going down connect the black wire
from switch. Connect these using the 2 butt connectors. Cut and strip the other
wire (white if they are color coded) and connect the white wire from the switch to
both ends of this wire using the closed end connector.
Summary of Contents for FLOJET 02095502
Page 27: ......
