Xycom XVME-500, Manual

Page: 18 / 104

XVME-500/590 Manual
February, 1988
Chapter 2
INSTALLATION
2 . 1 G E N E R A L
This chapter provides the information needed to configure
and install the Analog
Input Module.
2.2 SYSTEM REQUIREMENTS
The
XVME-500 Analog Input Module is single-height (3U), and the XVME-590 is
a
double-height (6U) VMEbus-compatible module. To operate, it must be properly
installed in a VMEbus backplane cardcage. The minimum system requirements for
operation of the module are one of the following:
A)
A
host processor installed in the same backplane
A properly installed controller subsystem. A n e x a m p l e o f s u c h a
subsystem is the XYCOM XVME-010 System Resource Module.
B) A host processor which incorporates an on-board controller subsystem
(such as the XVME-600 68000 Processing Module).
2.3 LOCATION OF COMPONENTS RELEVANT TO INSTALLATION
The jumpers, calibration potentiometers and connectors on the XVME-500 are
illustrated in Figure 2-1. Figure 2-1A shows the XVME-500 jumpers which have
multiple options. Figure 2-2 shows the jumpers, calibration potentiometers and
connectors on the XVME-590.
Figure 2-2A shows the XVME-590 jumpers which
have multiple options.
2-1
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com