AHIP6+ Manual
2-12
FPGA Program Connector (J15)
This eight-pin connector is used to program the lattice FPGA. This pinout matches
the standard lattice pinout.
ISA/IDE Backplane Connector (ATIDE1)
The ISA/IDE Backplane connector is a 120-pin connector. This connector provides
both ISA and IDE signals to the backplane.
IDE Connector (HDD1)
IDE hard drive connector is a 40-pin header. This header is intended for future op-
tions and testing.
PCI Backplane Connector (PCIMG1)
PCI backplane connector is a 120-pin connector.
Power Connector (PWR1)
This 20-pin connector is a standard ATX style PC power supply connector.
Touch Control Connector (TCTRL1)
This 40-pin connector supports 5-wire touchscreens. The connector is latching to
provide for a DRAM SIMM type installation.
Touch Connector (TCH1)
The five-pin touch connector is the interface to the touch panel.
Flat Panel Connector (FPNL1 and FPNL2)
The flat panel connector is a 60pin SMD through board connector. The four flat panel
select lines define up to 16 unique panel types. If all signals are high (no cable at-
tached) the system defaults to CRT.
The system board su5V and 3.3V TFT panels with a custom flat cable. It
supports STN panels with a 2.5” X 2.75” PCB which contains the DC/DC for the
custom VEE voltage along with the contrast and power sequencing circuit. There are
also provisions to support a temperature sensor for automatic contrast control.
