Xxxlutz 16970005/01, Manual

Page: 17 / 97

2 Set ON/OFF time and temperature on a weekly cycle
1. 3 times. When “ON” begins flashing, use to select
at any time to clear the digits and shut down
Press . When “MON” begins flashing, press
the desired hour and minute to turn on the heater.
“ON” timer.
note:
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)
. When “OFF” beginsflashing, use to select the desired hour and minute to turn off the heater.
at any time to clear the digits and shut down “OFF” timer.
2. Press
Press
3. Press again. When “18” begins flashing, use to select the desired temperature for Monday.
note:
If the temperature was previously set, those digits will be shown instead of “18”.
4. Press again. When “TUES” appears on the screen and “ON” begins flashing, use to select the desired
hour and minute to turn on the heater for Tuesday.
5. Press again. When “OFF” begins flashing, use to select the desired hour and minute to turn off the
heater for Tuesday.
6. Press again. When “18” begins flashing, use to select the desired temperature for Tuesday.
7. Repeat steps 1 to 6 to set the “ON/OFF” time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
8.
Press or to complete programming, ensuring to aim the remote control at the receiver, located in the
middle of the appliance. The appliance will “beep” once to confirm that programming has been successful.
Open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open window
nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if the heater is
already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash “88” 3 times
before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash “88” continuously.
To reset the heating function, see “operating remote control” section.
＠……
ov
配
AUTOMATIC SHUT-OFF
In case of overheating the appliance will automatically be shut o忏. If this occurs the electric
fireplace must be disconnected from the power outlet. The electric fireplace has to cool
down for approximately
20
minutes before reuse. Be sure that the air inlets and air outlets
are kept clean of dust, fluff, etc.
MAINTENANCE
Before carrying out maintenance work, disconnect the appliance from the power supply!