HK01x manual
3
1.
Connecting the device
The steps to connect the xxter device depend on the model that is used.
For all models the UTP cable has to be connected to the (internal)
network. xxter has to be able to connect to the Internet, to download
the configuration and for future firmware updates.
KNX direct
In case you are using an xxter model with a direct KNX-bus connection
(HK01 of HKE01), then connect the bus cable to pin 2 (KNX min/black)
and pin 3 (KNX plus/red), see image 6. First connect xxter to the KNX-
bus and then connect xxter’s power adaptor to the power socket.
Image 1: xxter rear panel
KNX connection over IP
When using KNX over a KNXnet/IP module, please make sure the xxter
unit and the KNXnet/IP module are both connected to the same
internal network.
Artnet DMX
For the use of DMX components, an ArtNet->DMX node is required.
This node must also be connected to the same internal network as the
xxter unit. A list of ArtNet->DMX nodes that are tested with xxter can
be found on the website.
Philips Hue
When using Philips Hue, make sure that the xxter unit and the Hue
network module (bridge) are both connected to the same internal
network.
