XWOW R2, Product Manual

Page: 26 / 48

2 3
PRODUCT USE
Introduction to sweeping and mopping functions
1. Pause: When the robot is executing a cleaning task, press the Start Button to pause the cleaning task,
and press the button again to continue cleaning; and press the Charge Button to return to the station
to charge. The cleaning task will be ended if you put the robot back into the station for charging when
pausing.
2. Sleep: The robot will be standby when it is paused for more than 10 minutes. If there is no operation
after the robot is standby for 10 minutes, status indicator will shut down. Press any button to wake the
robot up. When the robot is charging, it will not enter the sleep status. The robot will automatically
turn off after the sleep status lasts for over 6 hours.
3. Do Not Disturb mode: After Do Not Disturb mode is enabled (which is disabled by default), the default
Do Not Disturb period is from 10:00 p.m. to 08:00 a.m. You can change it by using the phone app.
During the Do Not Disturb period, the robot voice prompts will be disabled and the robot will not
continue to clean the area where it stopped.
4. Charging: After a cleaning task is ended, the robot will automatically return to the station to charge.
During charging, you can check battery level on the station screen or phone app. If the robot cannot
find the station, it will automatically return to the departure point. Please manually put the robot back
into the station.
5. Abnormal status: The indicator blinks red quickly and you will hear a voice prompt. For solutions,
please refer to the app or “Common issues” in this Product Manual. If there is no operation after the
abnormal status lasts for 10 minutes, the robot will automatically sleep.
6. Restore factory setting: To restore factory setting, please press and hold the Start Button and Charge
Button on the robot at the same time for 15 seconds when the robot is turned on. After you hear a
voice prompt saying that [Restoring factory setting succeeded], the robot will restore to its ex-factory
status. All saved data will be cleared up.
1. Before first use, it is recommended to fully charge the robot. Charging takes about 6 hours.
2. To help robot return to the station for automatic mop cleaning, clean water refilling, sewage draining,
and charging after a cleaning task is finished, it is recommended to let the robot depart from the
station. In addition, do not move the station, remove the clean water tank/sewage tank, or remove the
filter during cleaning.
3. Do not add unauthorized cleaning detergent. Otherwise, this may affect the station self-cleaning
function and cause the robot to skid.
4. If there is no task, the robot will enter sleep status after pausing for 10 minutes.
5. After the robot pauses or reports an error during work and there is no response after 10 minutes, the
robot will enter the sleep status and automatically end the current task in situ.
6. When the robot completes tasks, battery level lower than 20%, clean water box empty, or sewage
box full, the robot will automatically return to the station to clean the mop. After the robot is charged
to an appropriate battery level or after mop cleaning is finished, the robot will continue to clean the
area where it stopped.
7. Based on default cleaning path, the robot will clean a room along the wall first, and then move back
and forth in a S-shaped path. By default, if there is no personalized setting, the robot will clean the
room farthest from the station.
Other recommendations
Description of some common functions