STEP 6:
6.1 Connect the Video Output to the monitor or other video device
through a 75 Ohms type coaxial cable.
6.2 Connect the DC Jack or AC/DC Terminator with the power source.
6.3 Once the picture appears on the monitor, open the cover and make
the Zoom Adjustment by rotating the screw (NEAR-Anti-clockwise,
FAR-Clockwise) until you get the desired view. Next make the Focal
Adjustment by rotating the screw (TELE-Anti-clockwise, WIDE-
Clockwise) until you get the desired view. After adjustment tighten both.
STEP 4: Set the final image position by moving the camera body (some
model types limit the PCB board to 180° rotational
adjustment) and set the focus by turning the lens to the left or
right. When the camera focus adjustment is complete, replace
the dome housing by rotating clockwise to secure it (as shown
in Figure 3).
STEP 5: Secure the dome to the base of the camera by using the retaining
screw supplied (as shown in Figure 4).
Figure 3
Figure 4
Figure 5
Figure 2
Figure 6
