7 DIP Switch Setting
7.1 Flickerless Function- Set switch -OFF/FL to Flicker to enable
flickerless function. In this mode the switch AES/OFF is auto
disabled.
7.2 AGC-Hi/AGC-Lo Function- Adjusting the switch to AGC indicates
AGC-Hi and in the OFF position indicates AGC-Low. In AGC-Hi
mode, the maximum AGC gain is approximately 26dB. In AGC-Lo
mode, the maximum AGC gain is approximately 16dB.
7.3 Auto Iris Function- When using an Auto Iris lens the switch
AES/OFF should be in the OFF position to disable the AES
function. Adjust the LEVEL with the VR to the proper level.
7.4 BLC Function- Set switch OFF/BLC to BLC position to enable
Back Light Compensation (BLC) function
F.L.: Flickerless On/OFF
AGC: Auto Gain Control High/Low
AES: Auto Electronic Shutter
LLC: Back Light Compensation
VR Adjustment Level for DC Drive Lens
Inside Control Board
(Colour Normal Resolution)
•
Xvision IXC1HQE Digital Signal Processing (DSP) chip which has been
optimised for internal viewing and features Automatic Gain Control,
Automatic Electronic Iris, Auto White Balance, Back Light Compensation,
Low Smear, Edge Enhancement and Zero Colour Rolling
•
Xvision Pixel+ Varifocal 3.3 to 12.0mm Auto Iris lens with 23° to 90°
viewing angle for super sharp images and easy selection of the
optimum viewing angle during installation
•
Designed for internal use and ceiling mounting
STEP 1: Select a suitable position on the ceiling to install the camera.
STEP 2: Rotate the dome housing counterclockwise to remove it from
the mounting base (as shown in Figure 1).
STEP 3: Position the mounting base on to the ceiling and centre it over the
mounting hole. Fix with the four fixing screws (supplied). Allow the cable
connnectors to pass through (as shown in Figure 2).
Figure 1
Installation
