6 (16)
Crossover/Terminal
When XTZ produced the Divine 100.49 a great deal
of effort was put into the crossover filter. All
passive components are the highest quality to
minimize the influence on the signal. The
crossover is placed in a separate enclosure.
We use an optimal selection of air wound coils
(with low internal resistance) and coils with steel
cores (these accept a high level of magnetic
saturation), MKP capacitors and MOX resistors.
The terminal is divided into two input areas. One
for passive (normal) and one for active drive. All
terminal screws and inputs are gold plated.
The active inputs have direct connection with the
drivers. The thought behind this is that the speaker
can be used fully actively in the future to get the
most out of the system.
When using the bypass jumpers in the middle of
the terminal, the speaker is in “passive mode” and
connected to the passive cross over
It is possible to drive the woofers actively and gain
the possibility to use DSP based room correction.
There are three links/jumpers that can be used to
alter the character of the speaker.
One link/jumper for the tweeter (0 or +3dB)
One link/jumper for the midrange (0 or -2dB)
One link/jumper for the woofers (0 or +3dB)
Preparations
Unpacking
Carefully unpack the speaker, and pay attention so
you don't break anything. If possible, save the
carton box for future transportations. If there
should be damage on the loudspeaker, please
contact your retailer.
Accessories
Bass reflex plugs (4 pcs)
User manual
Links/Jumpers for level adjustment and
active/passive connection (18 pcs)
