Tango Studio User’s Guide | 6
Listening to your iPod
1.
Press the XtremeMac logo at the bottom of front of the unit
to open the universal dock well.
2.
Take the insert that came with your iPod and gently press the
insert into the universal dock well.
3.
Carefully place your iPod into the dock.
4.
Press the power button on top of the unit and the display will
light “iPod” to indicate the unit is powered and an iPod is
properly docked. The display will go off after 10 seconds.
5.
Press play on the iPod or on the included remote.
6.
Use the volume controls on the top of the unit or on the
included remote to set to the desired volume level. Use the iPod
to control songs or use the remote for next/previous track.
Note: If “iPod” is not shown on the display, use the source button
to select iPod mode and press play on the iPod or remote.
Listening to the FM radio
1.
Press the source button to select radio mode. The display will
show the station that was last used. The display will go off
after 10 seconds.
2.
Use the tuning controls on the top of the unit or on the
included remote to tune to the desired frequency. Holding
down the tuning controls will scroll quickly through stations.
3.
Use the volume controls on the top of the unit or on the
included remote to set to desired volume level.
Note: To ensure quality radio reception, Tango Studio will not
charge a docked iPod while FM radio is selected as the source.
Listening to an Auxiliary Source
1.
Connect the device to the “Line-in” jack on the back of the
unit with an auxiliary 3.5mm stereo audio cable (cable not
included).
2.
Press the source button on the top of the unit so that the
display shows “AUX”. The display will go off after 10 seconds.
3.
Press play on the device.
4.
Use the volume controls on the top of the unit or on the
included remote to set to desired volume level.
5 | Tango Studio User’s Guide
Unpacking and Initial Setup
1.
Remove Tango Studio from the box and remove foam and
protective plastic. Keep original packaging for 90 days and
then properly dispose.
2.
Place Tango Studio on a level surface following the
precautions listed in the safety warnings.
3.
Remove AC adapter from the packaging.
4.
Read and review manual and safety warnings
5.
Connect the AC adapter into the jack on the back of Tango
Studio labeled “12V DC ”, then plug the AC adapter into the
wall outlet.
6.
Untie and extend the FM antenna on the back of the unit so
that it is not tangled.
1. Retractable Universal
Dock Well
2. Power On/Off
3. Select Source
4. Previous/Next Track
(iPod)
Tune Up/Down Frequency
(Radio)
5. Volume Up/Down
6. LED Display
1. 12V DC Power Jack
2. Line-In Jack
3. FM Antenna
1. Power Button
2. Volume Up
3. Play (iPod)
4. Next Track (iPod)
Up Tuning (Radio)
5. Volume Down
6. Select Source
7. Previous Track (iPod)
Down Tuning (Radio)
1
6
1
2
3
4
5
1
6
3
6
4
5
1
7
2
2
3
tango_studio_manual.qxd 2/13/08 4:56 PM Page 9
