7
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
•
is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
This class B digital apparatus complies with Canadian ICES-003.
Note: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
gettIng starteD
Remove unit, AC adapter and remote from the box and
1.
properly dispose of any plastic or foam packaging material.
Place unit on a level surface close to a power outlet following
2.
the precautions listed in the safety warnings.
If located in the US, skip to step 6. If located outside the US,
3.
select the appropriate wall adapter. If already attached to the
unit, skip to step 6.
Press the button labeled "open" under the wall adapter to
4.
release the adapter.
Gently slide in the appropriate wall adapter. You will hear a
5.
click when it is properly locked into place.
Connect the AC adapter jack to the back of the unit labeled
6.
power and then connect the other end of the adapter to a
power outlet.
IPU-TRX-13_user_guide_23950664E.indd 7
8/15/11 10:11:29 AM
Imation Confidential - Use Only By Permission
Controlled material extracted from Matrix on Nov 29, 2012 10:03:45 AM CST
